News

The Motor Overheating Has A Great Influence On The Shredder

Apr 23, 2021 Leave a message

In the process of using the shredder, the motor overheated, forming the high temperature of the motor of the shredder is a multi-faceted element. Especially in the hot summer, not only people should pay attention to the heat protection, but also the mechanical equipment should pay attention to heat dissipation! The motor of the shredder should pay attention to heat dissipation in daily life. After the motor is heated, the insulation temperature of the motor winding will rise. The insulation response to high temperature is very fierce, which will accelerate aging and reduce the service life. If the temperature rise too high, it will make the insulation carbonization, lose the insulation effect, the winding of the motor will be short circuited and make the tearing machine defective. Therefore, it is very important to check, check and protect the motor overheating problems in terms of reducing the incident rate and reducing the loss of the incident and improving the economic benefits of the company. So, how can I know that the motor is overheating


1、 Hand feeling: that is, a method to estimate the temperature of motor by touching the regular parts of motor by hand and estimating the temperature of motor according to the strength and strength of hand heat.


2、 Thermometer method: that is to say, the temperature rise of the motor is directly measured by thermometer.


3、 Resistance method: the principle of conductor resistance increasing with temperature is used to measure.


Besides the external temperature is too high, there are also factors that can cause the motor to overheat


1. the air gap between the stator and rotor of the motor is very small, which causes the stator and rotor to collide. The simpler way to deal with it is to insert the end cover.


2. abnormal vibration or noise of motor causes the motor to generate heat. Cleaning should be done in specific conditions. Oscillation not only produces noise, but also produces rated load.


3. the bearing operation is abnormal, and the motor heating must be formed. Whether the bearing operation is normal can be judged by temperature experience. Check the bearing end by hand or thermometer to determine whether the temperature is within the normal range.


4. the power supply voltage is high, the excitation current increases, and the motor will be overheated. According to national standards, the change of motor power supply voltage shall not exceed the rated value ± 5%, the output power of motor can be maintained at rated value. The motor power supply voltage is not allowed to exceed the rated value ± 10%, the difference between three-phase power supply voltage shall not exceed the rated value ± 5%。


5. short circuit of winding, short circuit between turns, short circuit between phases and open circuit of winding. It is necessary to stop the machine immediately after this condition occurs.


6. material leakage enters the motor interior, which reduces the insulation of the motor, thus reducing the allowable temperature rise of the motor. It should be turned off to remove foreign matters.


7. motor is in phase short operation. In order to prevent the motor from running in phase, in addition to the accurate selection and installation of low-voltage appliances and protection devices, the relevant standards should be strictly followed, feeding lines should be laid, and regular inspection and protection of the shredder motor should be strengthened together.


Send Inquiry