1. Before starting the machine, it is necessary to check whether the components of the baler are intact; whether the screws and nuts of each component are loose, if any, they should be tightened in time. If there is a shortage of nails and hats, the repairman must be notified to deal with them in time.
2. Check if any debris is blocked in the conveyor belt. If there is debris, it must be cleaned with compressed air to blow away the dust in the guide rail.
3. Check whether the tool and slide parts are short of oil. If it is not necessary to use drip irrigation to add oil, use a small stick to simmer the oil and slowly drop it on top. The inverted method can not be poured into the feeding belt, otherwise the packaging is good. The belt will slip.
4. If abnormal phenomena are found during the startup process. Such as: loud sounds, large vibrations, odors, etc. If it is not found, it should be stopped by maintenance personnel to avoid damage to the components.
The last four points are maintenance methods for automatic waste paper packers. When using a waste paper packer, please pay attention to the maintenance of the waste paper packer.
The automatic waste paper packer has the characteristics of good toughness, good stability, beautiful appearance, convenient operation and maintenance, safety and energy saving, and low investment cost of equipment infrastructure projects. Widely used in various waste paper mills, old material recycling companies and other unit enterprises. Suitable for packaging and recycling of used paper and plastic straws.
The reason why the waste paper packer has more than enough energy and insufficient work:
1. The air pressure of the waste paper baler oil pump is not as high as the flow demand. In order to prevent oil leakage at the age of years, it is necessary for the waste paper packer to make moderately tight inspections and tests before proceeding.
2. If the safety valve of the waste paper baler is deformed in the light pressure baler, it will seriously affect the main spool and prevent it. The main spool is blocked at the small opening, which will cause the pressure oil at the side of the door source packing pump to overflow into the oil tank and make the baling machine oil. The flow rate of the actuator from the waste paper packer is greatly reduced, so the oil supply progress is slowed down.
3. The front and back drainage of the waste paper baler is serious. When acting fast, it is easy to cause the wind pressure to be too low, but the far pressure overturns the oil return circuit. It is easy to cause a fork with too much air leakage, resulting in a quick move of the waste paper packing machine cylinder.